Skip to main content
Skip table of contents

Configuring the Back End of LPR

Overview

This page describes how to configure YSoft SafeQ 6 to work with a printer over the Line Printer Remote protocol (LPR).

Configuration

  1. Log into the YSoft SafeQ management interface with sufficient rights to administer printers (for example, "admin"). Go to Devices > Printers > Edit device > Advanced tab.
  2. Set Back-end to the LPR value. You also have to define the printer's LPR queue and port, which must be configured the same way as on the MFD. Click Save Changes to apply these settings.
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.